Connecting procedure

NOTE:
The connecting procedure must be performed when the vehicle is stationary. If the vehicle starts moving during the procedure, the procedure will be cancelled.

1. Push the  button on the

1. Push the steering wheel. button on the steering wheel.

The system announces the available commands.

2. Say: “Connect Phone” A . The system acknowledges the command and announces the next set of available commands.

3. Say: “Add phone” B . The system acknowledges the command and asks you to initiate pairing from the phone handset C .

The connecting procedure of the cellular phone varies according to each cellular phone. See the cellular phone Owner’s Manual for details. You can also visit www.

nissanusa.com/bluetooth for instructions on connecting NISSAN recommended cellular phones.

When prompted for a Passkey code, enter “1234” from the handset. The Passkey code “1234” has been assigned by NISSAN and cannot be changed.

4. The system asks you to say a name for the phone D .

If the name is too long or too short, the system tells you, then prompts you for a name again.

Also, if more than one phone is connected and the name sounds too much like a name already used, the system tells you, then prompts you for a name again.

    See also:

    Variable voltage control system
    CAUTION: - Do not ground accessories directly to the battery terminal. Doing so will bypass the variable voltage control system and the vehicle battery may not charge completely. - Use ele ...

    Zone variation change procedure
    Zone map The difference between magnetic north and geographical north is known as variance. In some areas, this difference can sometimes be great enough to cause false compass readings. Foll ...

    Brake and clutch (if so equipped) fluid
    For further brake and clutch fluid specification information, refer to “Capacities and recommended fuel/lubricants” in the “Technical and consumer information” section of this manual. ...