Heater operation

Heating:

This mode is used to direct heated air to the foot outlets.

1. Push the air recirculation button to the to the OFF position. (The indicator light turns off.) 2. Turn the air flow control dial to the position. position.

3. Turn the fan speed control to the dial to the desired position.

4. Turn the temperature control dial to the desired position between the middle and the hot (right) position.

Ventilation:

This mode directs outside air to the side and center ventilators.

1. Push the air recirculation button to the to the OFF position. (The indicator light turns off.) 2. Turn the air flow control dial to the position. position.

3. Turn the fan speed control to the dial to the desired position.

4. Turn the temperature control dial to the desired position.

Defrosting or defogging:

This mode directs the air to the defroster outlets to defrost/defog the windows.

1. Turn the air flow control dial to the position.

2. Turn the fan speed control dial to the desired position. desired position.

3. Turn the temperature control dial to the dial to the desired position between the middle and the hot (right) position.

- To remove frost from the outside surface of the windshield quickly, turn the temperature control dial to the maximum hot position and the fan speed control maximum dial to maximum (HI) position.

- If it is difficult to defog the windshield, turn the A/C button on.

Bi-level heating:

This mode directs cool air from the side and center vents and warm air from the foot outlets.

When the temperature control dial is turned to the maximum hot or cool position, the air between the ventilators and the foot outlets is the same temperature.

1. Push the air recirculation button to the to the OFF position. (The indicator light turns off.) 2. Turn the air flow control dial to the position. position.

3. Turn the fan speed control to the dial to the desired position.

4. Turn the temperature control dial to the desired position.

Heating and defogging:

This mode heats the interior and defogs the windows.

1. Turn the air flow control dial to the position. position.

2. Turn the fan speed control to the dial to the desired position.

3. Turn the temperature control dial to the desired position.

    See also:

    Draining of coolant water
    If the vehicle is to be left outside without antifreeze, drain the cooling system, including the engine block. Refill before operating the vehicle. For details, see “Changing engine coolant” ...

    LATCH (Lower Anchors and Tethers for CHildren) System
    LATCH system lower anchor locations Your vehicle is equipped with special anchor points that are used with LATCH (Lower Anchors and Tethers for CHildren) system compatible child restraints. T ...

    Antenna
    Antenna To remove the antenna, hold the bottom of the antenna and turn it counterclockwise. To install the antenna, turn the antenna clockwise and tighten. - To avoid damaging or deformin ...