Washing

Wash dirt off with a wet sponge and plenty of water. Clean the vehicle thoroughly using a mild soap, a special vehicle soap or general purpose dishwashing liquid mixed with clean, lukewarm (never hot) water.

● Do not use car washes that use acid in

● Do not use car washes that use acid in the detergent. Some car washes, especially brushless ones, use some acid for cleaning. The acid may react with some plastic vehicle components, causing them to crack. This could affect their appearance, and also could cause them not to function properly. Always check with your car wash to confirm that acid is not used.

● Do not wash the vehicle with strong household soap, strong chemical detergents, gasoline or solvents.

● Do not wash the vehicle in direct sunlight or while the vehicle body is hot, as the surface may become water-spotted.

● Avoid using tight-napped or rough cloths, such as washing mitts. Care must be taken when removing caked-on dirt or other foreign substances so the paint surface is not scratched or damaged.

Rinse the vehicle thoroughly with plenty of clean water.

Inside flanges, seams and folds on the doors, hatches and hood are particularly vulnerable to the effects of road salt. Therefore, these areas must be cleaned regularly. Take care that the drain holes in the lower edge of the door are open. Spray water under the body and in the wheel wells to loosen the dirt and wash away road salt.

A damp chamois can be used to dry the vehicle to avoid water spots.

    See also:

    Clutch fluid (if so equipped)
    Check the clutch fluid level in the reservoir (manual transmissions only). Add Genuine NISSAN Super Heavy Duty Brake Fluid or equivalent DOT 3 fluid up to the MAX line A . If fluid must be a ...

    POWER on/off switch
    If you have the Type A switch, with the ignition switch placed in the ACC or ON position, push the POWER switch to turn the audio system on or off. If you have the Type B switch, with the ignit ...

    Activating Alternate Command Mode
    1. Press the SETTING button on the instrument panel. 2. Select the “Others” key on the display. 3. Select the “Voice Recognition” key. 4. Select the “Alternate Command Mode” key. ...