Manual control
While using the voice recognition system, it is
possible to select menu options by using the
steering wheel controls instead of speaking voice
commands. The manual control mode does not
allow dialing a phone number by digits. The user
may select an entry from the Phonebook or Recent
Calls lists. To re-activate voice recognition,
exit the manual control mode by pressing and
holding the PHONE/END (
) button. At that
time, pressing the PHONE/SEND (
) button
will start the Hands Free Phone System.
Operating tips
● To enter manual control mode, start the
voice recognition system and tilt the tuning
(
) switch up or down. The system
will
speak Showing Manual Options when
manual controls are initially activated.
● To browse the menu options, tilt the tuning
(
) switch up or down. The system
will
always speak the current menu option. Depending
on the audio display, it will also
show the current menu option.
● To select the current menu option, press the
PHONE/SEND () button.
● To go back to the previous menu, press the
PHONE/END () button. If the current
menu is the Main Menu, pressing the
PHONE/END () button will exit the
Phone system.
● To exit the manual control mode, press and
hold the PHONE/END () button for 5
seconds.
See also:
Suggested up-shift speeds
The following are suggested vehicle speeds for
shifting into a higher gear. These suggestions
relate to fuel economy and vehicle performance.
Actual upshift speeds will vary according to road
cond ...
Rear seats
Folding
Before folding the rear seats:
- Secure the seat belts on the seat belt hooks
on the side wall. (See “Seat belt hooks” later
in this section.)
- Release the connector tongue of t ...
Continuously Variable Transmission (CVT) fluid
- Use only Genuine NISSAN CVT Fluid
NS-2. Do not mix with other fluids.
- Using transmission fluid other than
Genuine NISSAN CVT Fluid NS-2
will damage the CVT, which is not
covered by th ...