Audio main operation

POWER/VOLUME control:

Place the ignition switch in the ACC or ON position. Press the PWR button while the system is off to call up the mode (radio, CD or AUX) that was playing immediately before the system was turned off. While the system is on, pressing the PWR button turns the system off.

Turn the VOL control knob to adjust the volume.

MENU button (Bass, Treble, Fade, Balance and Clock):

Press the MENU button to change the mode as follows.

BAS (Bass) → TRE (Treble) → FAD (Fade) → BAL (Balance) → Clock → Normal mode

Press the SEEK or or or or TUNE or or button to adjust the Bass, Treble, Fade button to adjust the Bass, Treble, Fade and Balance to the desired level. Fade adjusts the sound level between the front and rear speakers and Balance adjusts the sound between the right and left speakers.

Once you have adjusted the sound quality to the desired level, press the MENU button repeatedly until the radio or CD display reappears. If no action is taken, the radio or CD display will automatically reappear after approximately 10 seconds.

Clock set

If the clock is not displayed with the ignition switch in the ACC or ON position, you need to select the CLK-ON mode. Press the MENU button repeatedly until CLK-OFF mode is displayed.

Use the TUNE/FF-REW/FOLDER button to enable CLK-ON mode.

1. Press the MENU button repeatedly until “Clock:” appears. The hours will begin flashing.

2. Press the SEEK button oror the TUNE button or the TUNE button or  to adjust or the hours. to adjust the hours.

3. Press the MENU button again. The minutes will begin flashing.

4. Press the SEEK button or or the TUNE button or the TUNE button or or the minutes. to adjust the minutes.

5. Press the MENU button again to exit the clock set mode.

If no action is taken, the display will return to the regular clock display after 10 seconds.

    See also:

    Fuel gauge
    Fuel gauge NOTE: The ignition switch must be placed in the ON position for the gauge to give a reading. The gauge indicates the approximate fuel level in the tank. The gauge may move slig ...

    iPod® player operation
    Connecting iPod®: The USB outlet connector is located in the center console. Open the lid and connect the iPod® cable to the USB connector. The battery of the iPod® is charged while the co ...

    Terms
    It is important to familiarize yourself with the following terms before loading your vehicle. ● Curb Weight (actual weight of your vehicle) - vehicle weight including. standard and optio ...