Connecting procedure

NOTE:

The connecting procedure must be performed when the vehicle is stationary. If the vehicle starts moving during the procedure, the procedure will be cancelled.

1. Press the  button on the

1. Press the steering button on the steering wheel. The system announces the available commands.

2. Say: “Connect phone” A . The system acknowledges the command and announces the next set of available commands.

3. Say: “Add phone” B . The system acknowledges the command and asks you to initiate connecting from the phone handset C .

The connecting procedure of the cellular phone varies according to each cellular phone model. See the cellular phone Owner’s Manual for details. You can also visit www.nissanusa.com/bluetooth for instructions on connecting NISSAN recommended cellular phones.

When prompted for a Passkey code, enter “1234” from the handset. The Passkey code “1234” has been assigned by NISSAN and cannot be changed.

4. The system asks you to say a name for the phone D .

If the name is too long or too short, the system tells you, then prompts you for a name again.

Also, if more than one phone is connected and the name sounds too much like a name already used, the system tells you, then prompts you for a name again.

    See also:

    Locking with inside lock knob
    Inside lock To lock the door without the key, move the inside lock knob to the lock position 1 , then close the door. To unlock the door without the key, move the inside lock knob to the unlock ...

    Checking tire pressure
    1. Remove the valve stem cap from the tire. 2. Press the pressure gauge squarely onto the valve stem. Do not press too hard or force the valve stem sideways, or air will escape. If the hissing ...

    Ending a call
    To finish the call, perform one of the following procedures: ● Select the “Hang up” key on the “Call in Progress” display. ● Push the switch on the steering wheel. ...