Speaker adaptation (SA) mode
Speaker Adaptation allows up to two out-ofdialect users to train the system to improve recognition accuracy. By repeating a number of commands, the users can create a voice model of their own voice that is stored in the system. The system is capable of storing a different speaker adaptation model for each connected phone.
Training procedure
The procedure for training a voice is as follows.
1. Position the vehicle in a reasonably quiet outdoor location.
2. Sit in the drivers seat with the engine running, the parking brake on, and the transmission in P (Park).
3. Press and hold the button for more than 5 seconds.
4. The system announces: Press the PHONE/SEND ( ) button for the hands-free phone system to enter the speaker adaptation mode or press the PHONE/END ( ) button to select a different language.
5. Press the button.
For information on selecting a different language, see Choosing a language in this section.
6. Voice memory A or memory B is selected automatically. If both memory locations are already in use, the system will prompt you to overwrite one. Follow the instructions provided by the system.
7. When preparation is complete and you are ready to begin, press the button.
8. The SA mode will be explained. Follow the instructions provided by the system.
9. When training is finished, the system will tell you an adequate number of phrases have been recorded.
10. The system will announce that speaker adaptation has been completed and the system is ready.
The SA mode will stop if:
- The button is pressed for more than 5 seconds in SA mode.
- The vehicle begins moving during SA mode.
- The ignition switch is placed in the OFF or LOCK position.
Training phrases
During the SA mode, the system instructs the trainer to say the following phrases. (The system will prompt you for each phrase.) - phonebook transfer entry.
- dial three oh four two nine.
- delete call back number.
- incoming.
- transfer entry.
- eight pause nine three two pause seven.
- delete all entries.
- call seven two four zero nine.
- phonebook delete entry.
- next entry.
- dial star two one seven oh.
- yes.
- no.
- select.
- missed.
- dial eight five six nine two.
- Bluetooth on.
- outgoing.
- call three one nine oh two.
- nine seven pause pause three oh eight.
- cancel.
- call back number.
- call star two zero nine five.
- delete phone.
- dial eight three zero five one.
- record name.
- four three pause two nine pause zero.
- delete redial number.
- phonebook list names.
- call eight oh five four one.
- correction.
- connect phone.
- dial seven four oh one eight.
- previous entry.
- delete.
- dial nine seven two six six.
- call seven six three oh one.
- go back.
- call five six two eight zero.
- dial six six four three seven.
See also:
USB interface (models without Navigation System) (if so equipped)
Connecting a device to the USB input
jack
The USB input jack is located in the center console.
Open the protective cover (1) on the USB
jack, then insert the USB device into the jack.
When a ...
Locking doors
Locking doors
1. Place the ignition switch in the LOCK position.
(Remove the key if any key is in the
ignition switch.)
2. Close all doors.
3. Push any door handle request switch 1
while ca ...
FM/AM radio operation
FM/AM band select:
Pressing the RADIO button will change the band
as follows:
AM ←→ FM
When the RADIO button is pressed while the
ignition switch is in the ACC or ON position, the
ra ...