Auto-reverse function (if so equipped)

There are some small distances immediately before the closed position which cannot be detected. Make sure that all passengers have their hands, etc., inside the vehicle before closing the window.
If the control unit detects something caught in the window as it is closing, the window will be immediately lowered.
The auto reverse function can be activated when the window is closed by automatic operation when the ignition switch is in the ON position or for 45 seconds after the ignition switch is turned to the OFF position.
Depending on the environment or driving conditions, the auto reverse function may be activated if an impact or load similar to something being caught in the window occurs.
See also:
Vents
Adjust air flow direction for the driver’s and passenger’s
side 1 , and center 2 ventilators by
moving the ventilator slide and/or ventilator assemblies.
Open or close the ventilators 1 by ...
Headlight beam select
Headlight beam select
1 To select the low beam, put the lever in the neutral
position as shown.
2 To select the high beam, push the lever forward
while the switch is in the position. Pull it ...
Car Not Go
The Cube's four-cylinder engine offers up modest power at best, and it emits
a muffled roar when pushed hard. There's little fun to be had at higher revs,
which might have sufficed a decade ago. T ...
