Maintenance precautions
When performing any inspection or maintenance work on your vehicle, always take care to prevent serious accidental injury to yourself or damage to the vehicle. The following are general precautions which should be closely observed.
● Park the vehicle on a level surface, apply the parking brake securely and block the wheels to prevent the vehicle from moving. For manual transmission models, move the shift selector to N (Neutral). For CVT models, move the shift selector to P (Park).
● Be sure the ignition switch is in the OFF or LOCK position when performing any parts replacement or repairs.
● If you must work with the engine running, keep your hands, clothing, hair and tools away from moving fans, belts and any other moving parts.
● It is advisable to secure or remove any loose clothing and remove any jewelry, such as rings, watches, etc. before working on your vehicle.
● Always wear eye protection whenever you work on your vehicle.
● If you must run the engine in an enclosed space such as a garage, be sure there is proper ventilation for exhaust gases to escape.
● Never get under the vehicle while it is supported only by a jack. If it is necessary to work under the vehicle, support it with safety stands.
● Keep smoking materials, flame and sparks away from the fuel tank and battery.
● On gasoline engine models, the fuel filter or fuel lines should be serviced by a NISSAN dealer because the fuel lines are under high pressure even when the engine is off.
● Do not work under the hood while the engine is hot. Turn the engine off and wait until it cools down.
● Avoid contact with used engine oil and coolant. Improperly disposed engine oil, engine coolant and/or other vehicle fluids can damage the environment. Always conform to local regulations for disposal of vehicle fluid.
● Never leave the engine or the CVT related component harness connector disconnected while the ignition switch is in the ON position.
● Never connect or disconnect the battery or any transistorized component while the ignition switch is in the ON position.
● Your vehicle is equipped with an automatic engine cooling fan. It may come on at any time without warning, even if the ignition key is in the OFF position and the engine is not running. To avoid injury, always disconnect the negative battery cable before working near the fan.
This “Maintenance and do-it-yourself” section gives instructions regarding only those items which are relatively easy for an owner to perform.
A genuine NISSAN service manual is also available.
See “Owner’s Manual/Service Manual order information” in the “Technical and consumer information” section of this manual.
You should be aware that incomplete or improper servicing may result in operating difficulties or excessive emissions, and could affect warranty coverage. If in doubt about any servicing, have it done by a NISSAN dealer.
See also:
Freeing a frozen door lock
To prevent a door lock from freezing, apply deicer
through the key hole. If the lock becomes
frozen, heat the key before inserting it into the key
hole or use the remote keyless entry keyfob (if ...
Headlights
Replacing the halogen headlight bulbThe headlight
is a semi-sealed beam type which
uses a replaceable headlight (halogen) bulb. Because
the headlight assembly must be removed
from the vehicle ...
Fuel recommendation
NISSAN recommends the use of premium unleaded
gasoline with an octane rating of at least
91 AKI (Anti-Knock Index) number (Research
octane number 96). If unleaded premium gasoline
is not avail ...