Audio main operation
POWER/VOLUME control:
Place the ignition switch in the ACC or ON position. Press the PWR button while the system is off to call up the mode (radio, CD or AUX) that was playing immediately before the system was turned off. While the system is on, pressing the PWR button turns the system off.
Turn the VOL control knob to adjust the volume.
MENU button (Bass, Treble, Fade, Balance and Clock):
Press the MENU button to change the mode as follows.
BAS (Bass) → TRE (Treble) → FAD (Fade) → BAL (Balance) → Clock → Normal mode
Press the SEEK or
or TUNE
or
button to adjust the Bass, Treble, Fade
and Balance to the desired level. Fade adjusts
the sound level between the front and rear speakers
and Balance adjusts the sound between the
right and left speakers.
Once you have adjusted the sound quality to the desired level, press the MENU button repeatedly until the radio or CD display reappears. If no action is taken, the radio or CD display will automatically reappear after approximately 10 seconds.
Clock set
If the clock is not displayed with the ignition switch in the ACC or ON position, you need to select the CLK-ON mode. Press the MENU button repeatedly until CLK-OFF mode is displayed.
Use the TUNE/FF-REW/FOLDER button to enable CLK-ON mode.
1. Press the MENU button repeatedly until “Clock:” appears. The hours will begin flashing.
2. Press the SEEK button
or
or
the TUNE button
or
to adjust
the hours.
3. Press the MENU button again. The minutes will begin flashing.
4. Press the SEEK button or
or
the TUNE button
or
to adjust
the minutes.
5. Press the MENU button again to exit the clock set mode.
If no action is taken, the display will return to the regular clock display after 10 seconds.
See also:
Forward-facing child restraint installation using latch
Refer to all Warnings and Cautions in the Child
Safety and Child Restraint sections before installing
a child restraint.
Follow these steps to install a forward-facing
child restraint using the ...
Opening windows (if so equipped)
The Intelligent Key allows you to open windows
equipped with automatic operation simultaneously.
● To open the windows, press the
button
on the Intelligent Key longer than 3
seconds after ...
Vehicle Dynamic Control
(VDC) OFF indicator light
This indicator light comes on when the Vehicle
Dynamic Control off switch is pushed to OFF.
This indicates the Vehicle Dynamic Control has
been turned off.
Push the Vehicle Dynamic Control off s ...