Memory storage function
Two positions for the drivers seat, steering column, and outside mirrors can be stored in the automatic drive positioner memory. Follow these procedures to use the memory system.
1. Set the Continuously Variable Transmission (CVT) shift selector to the P (Park) position.
2. Place the ignition in the ON position.
3. Adjust the drivers seat, steering column, and outside mirrors to the desired positions by manually operating each adjusting switch. For additional information, see Seats in the SafetySeats, seat belts and supplemental restraint system section and Outside mirrors in this section.
During this step, do not place the ignition switch in any position other than ON.
4. Push the SET switch and, within 5 seconds, push the memory switch (1 or 2).
The indicator light for the pushed memory switch will come on and stay on for approximately 5 seconds after pushing the switch.
After the indicator light goes off, the selected positions are stored in the selected memory (1 or 2).
If a new memory is stored in the same memory switch, the previous memory will be deleted.
Linking a keyfob to a stored memory position
Each keyfob can be linked to a stored memory position (memory switch 1 or 2) with the following procedure.
1. Follow the steps for storing a memory position.
2. While the indicator light for the memory
switch being set is illuminated for 5 seconds,
press the button on the
keyfob.
The indicator light will blink. After the indicator light goes off, the keyfob is linked to that memory setting.
With the ignition switch placed in the OFF position,
press the button on the
keyfob. The
drivers seat and outside mirrors will move to the
memorized position.
NOTE:
If a new memory position is saved to the memory switch, the keyfob automatically re-links.
Confirming memory storage - Place the ignition switch in the ON position and push the SET switch. If the main memory has not been stored, the indicator light will come on for approximately 0.5 seconds.
When the memory has stored the position, the indicator light will stay on for approximately 5 seconds.
- If the battery cable is disconnected, or if the fuse opens, the memory storage function will be canceled and must be restarted before a stored memory position can be set again.
Drive the vehicle over 25 MPH (40 km/h) to restart the memory storage function. You can also restart the memory storage function using the following procedure.
1. Connect the battery cable or replace the fuse.
2. Open and close the drivers door more than 2 times with the ignition switch in the LOCK position.
Once the memory storage function has been restarted, you can store a memory position.
See Memory storage function in this section.
Selecting the memorized position
Set the shift selector to the P (Park) position, then:
- Within 45 seconds of opening the drivers door, push the memory switch (1 or 2) or - Place the ignition switch in the ON position and push the memory switch (1 or 2).
The drivers seat, steering column, and outside mirrors will move to the memorized position with the indicator light blinking, and then the light will stay on for approximately 5 seconds.
See also:
All season tires
NISSAN specifies All Season tires on some models
to provide good performance all year, including
snowy and icy road conditions. All Season
tires are identified by ALL SEASON and/or M&S
on ...
Locking with power door lock switch
Door lock switch
To lock all the doors without a key, push the door
lock switch (driver’s or front passenger’s side) to
the lock position 1 . When locking the door this
way, be certain no ...
Operating tips
● Keep the windows and moonroof closed
while the air conditioner is in operation.
● After parking in the sun, drive for 2 or 3
minutes with the windows open to vent hot
air from the ...