If the windows do not close automatically

If the power window automatic function (closing only) does not operate properly, perform the following procedure to initialize the power window system.

1. Turn the ignition switch to the ON position.

2. Close the door.

3. Open the window completely by operating the power window switch.

4. Pull the power window switch and hold it to close the window, and then hold the switch more than 3 seconds after the window is closed completely.

5. Release the power window switch. Operate the window by the automatic function to confirm the initialization is complete.

If the power window automatic function does not operate properly after performing the procedure above, have your vehicle checked by a NISSAN dealer.

    See also:

    Rear-facing child restraint installation using LATCH
    Refer to all Warnings and Cautions in the “Child safety” and “Child restraints” sections before installing a child restraint. Follow these steps to install a rear-facing child restraint ...

    Off-road recovery
    If the right side or left side wheels unintentionally leave the road surface, maintain control of the vehicle by following the procedure below. Please note that this procedure is only a general gui ...

    Compatibility
    The following models are compatible: ● iPod 5th Generation version 1.2.3 ● iPod Classic - version 1.1 ● iPod Touch - version 2.1* ● iPod Nano - 1st generation version 1 ...